Current position > News detail
『Electromagnetic flowmeter flow rate』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
What are the measurement ranges of electromagnetic flow meters? The range of an electromagnetic flowmeter depends on multiple factors, including its size and diameter, design parameters, and the physical properties of the fluid being measured. Under normal circumstances, electromagnetic flow meters can provide a fairly wide measurement range. Here are some reference data: the flow velocity measurement range is generally 0.05 to 10 meters per second (m/s). According to the different nominal diameters (DN) of Zhengzhuo, the measurable flow range varies: for example, for a DN10 electromagnetic flowmeter, the measurable flow range is approximately between 0.0142 and 3.3912 cubic meters per hour (m ³/h). The effective measurement flow range of DN15 electromagnetic flowmeter may be 0.0318 to 7.6302 m ³/h. The measurement range of electromagnetic flow meters is usually large, ranging from 20:1 to 50:1, which means that the ratio of maximum flow rate to minimum flow rate can reach this range. The caliber range is very wide, ranging from a few millimeters (mm) to pipes with sizes exceeding DN6000 or even larger. Choosing an electromagnetic flowmeter requires determining the appropriate range and diameter based on the expected flow rate in practical applications, fluid conductivity, pipeline size, and process requirements to ensure accurate and effective measurement. In addition, the specific range of electromagnetic flow meters produced by different manufacturers may vary, and should be selected according to the product specification table. 2. Flow rate of electromagnetic flowmeter
The flow calculation and selection of electromagnetic flowmeter should focus on the pipe diameter, flow velocity, and magnetic fiel
1. Analysis of Flow Calculation Formula 1 Basic formula: The core principle is based on $E=k \ cdot B \ cdot v \ cdot D $, where the induced electromotive force $E $is proportional to the magnetic induction intensity $B $, flow velocity $v $, and pipe diameter $D $
2. Flow formula variant: - $Q=k \ cdot B \ cdot D \ cdot v $is a direct expression, $Q $represents volumetric flow rate, and the unit is usually $m ³/h $or $L/s. -$Q=3600 \ times V \ times S $is a simplified engineering formula, $V $is the average flow velocity (m/s), $S=π D ²/4 $is the cross-sectional area of the conduit, which is suitable for fast calculation.
2. Measurement Range and Selection Principles 1 Flow rate range: Conventional electromagnetic flow meters support flow rates of 0.5-15m/s, with a range ratio of 150:1, and high adaptability to cover micro flow to high flow rate scenarios. Range configuration: It is necessary to ensure that the nominal range Q is greater than the actual maximum flow rate, and the ideal operating flow rate value is 50%~80% of the full range to avoid accuracy degradation caused by low flow rates.
III. Examples of correspondence between pipe diameter and flow rate Taking two typical diameters as examples: • Small diameter (10mm): minimum flow rate of 0.03m ³/h, maximum flow rate of 4.24m ³/h, suitable for detailed flow monitoring.
. Medium caliber (100mm): covering 2.82~424m ³/h, suitable for high flow scenarios in industrial pipelines. When selecting, it is necessary to comprehensively consider the fluid conductivity (≥ 5 μ S/cm) and actual pipeline parameters. Oth