What are the installation requirements for a dual rotor flowmeter?

『Installation requirements for rotor flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)

1. What are the installation and connection methods for high-precision dual rotor flow meters?

The installation and installation connection methods for high-precision dual rotor flow meters are mainly divided into three categories: flange connection, threaded connection, and clamp connection, with different specific adaptation scenarios and operating points. 1. Flange connection is the most commonly used installation method in industrial scenarios, suitable for large flow meters with a diameter ≥ DN25: - Installation preparation: Confirm in advance that the flange end face of the pipeline is flat and free of burrs, and use rubber/metal gaskets with the same pressure level as the flowmeter flange. The bolts should be gradually tightened in diagonal order to avoid uneven stress and leakage. -Applicable scenarios: Large diameter and high-pressure working conditions such as water supply and drainage, chemical fluid transportation, crude oil transportation, etc.

2. Threaded connections are mostly used for small flow meters with a diameter ≤ DN50, suitable for civilian or small industrial low-pressure scenarios: - Installation preparation: Raw material tape needs to be wrapped around the thread or sealed with sealant, and the tightening direction should be consistent with the fluid flow arrow to avoid excessive force damaging the thread sealing surface. -Suitable scenarios for Zheng Qin: small laboratory fluid metering, household water purification systems, small HVAC pipelines

3. Clamping and connecting adapter pipelines that require quick disassembly in the middle, commonly used in sanitary conditions: - Installation preparation: The flowmeter needs to be clamped between the flanges of two pipeline sec

Installation requirements for rotor flowmeter

tions, evenly pressed and fixed with fastening bolts at both ends, and equipped with special clamping gaskets to ensure sealing. -Applicable scenarios: Food and beverage production, clean pipelines in the pharmaceutical industry, and fluid metering scenarios that require regular cleaning and maintenance. Additional precautions should be taken during installation to ensure sufficient straight pipe sections before and after the flowmeter: at least 10 times the pipe diameter length should be reserved upstream, and 5 times the pipe diameter length should be reserved downstream to avoid turbulence affecting measurement accuracy; At the same time, it is necessary to ensure that the direction of the flow meter arrow is consistent with the direction of fluid flow, and reverse installation is strictly prohibited after the trace is completed.

2. Installation and use method of plastic tube rotor flowmeter

The installation and use method of LZS series plastic tube rotor flowmeter is as follows:

1. Installation method of Kuankai Brother: Connect directly by inserting and bonding: Use ABS or PVC plastic tube, directly insert into the flowmeter interface with special adhesive and fix it.

. Flange connection: If it needs to be connected to a metal pipeline, ABS or PVC flanges should be used to bond the flowmeter first, and then the flange should be connected to the metal pipeline to ensure sealing. Installation direction and angle perpendicular installation: The flowmeter must be installed vertically on the pipeline, with a tilt angle of less than 5 °, otherwise measurement errors may occur due to uneven force on the rotor. Direction identification: During installation, it is necessary to ensure that the flow dir

What are the installation requirements for a dual rotor flowmeter?

1. What are the installation and connection methods for high-precision dual rotor flow meters?

2. Installation and use method of plastic tube rotor flowmeter

『SILVER Official Website SERVICE』